Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

P148
EPM Default Value:
Description: DHCP Vendor Class ID, DHCP option 60. Max length allowed is 64 characters.
Phone Default Value: udhcp 1.12.1

P149
EPM Default Value:
Description: DHCP User Class

...

P92
EPM Default Value: 8
Description: DNS Server 1'st octectoctet

P93
EPM Default Value: 8
Description: DNS Server 2'nd octectoctet

P94
EPM Default Value: 8
Description: DNS Server 3'rd octet

...

P207
EPM Default Value:
Description: System Log.Syslog Server
Values: Dotted IP address of server, not inclusive of port definition.  Port defaults to 514 and is not configurable.

P208
EPM Default Value: 0
Description: System Log.Syslog level 0 - NONE, 1 - DEBUG, 2 - INFO, 3 - WARNING, 4 - ERROR

...

P23400
EPM Default Value: 1
Description:  Auto Answer Alert 0 - Disable, 1 - Enable

P24887
EPM Default Value: 0
Description:  Call Pickup, Send Pickup Code on Refer 0 - Disable, 1 - Enable.  Phone default is 1.

P24792
EPM Default Value: 0
Description: If enabled, causes incoming Intercom calls to be put to the loudspeaker, rather than the headset, if the phone is otherwise configured for headset mode.  Defaults to 0.  To enable, set to 1. 

P23406
EPM Default Value: 0
Description: If enabled, while the phone is in the ringing state due to an inbound call, and the user presses a BLF or speed dial button, the phone will generate a new call to the BLF or speed dial. If disabled, the phone will blind transfer the incoming call to the BLF or speed dial destination.  Defaults to 0.  To enable, set to 1. 

P24972
EPM Default Value: 0
Description: If enabled, the phone, if on non-primary pages of BLF keys, will return to the primary page following a timeout set by this option. The timeout is in seconds and is from 1-120. Defaults to 0 (disabled). Added in x.0.4.77.

P24953
EPM Default Value: 0
Description: If enabled, only send pickup 
prefix codes on BLF keypress while the phone is idle. If disabled, send always. Defaults to 0. To enable, set to 1. Added in x.0.4.76.