Where can I find configuration instructions for my new service?
Detailed instructions are available at www.freepbx.org/freepbx-trunks. You can also install our module from the FreePBX online repository in Module Admin and auto configure your trunks in FreePBX with a key you obtain from your portal.
Frequently Asked Questions
Table of Contents minLevel 2
How do I set up my SIPStation service with FreePBX the easy way?
For FreePBX versions 2.5 or newer, we have a simple module included in FreePBX called "SIPStation," which makes setting up your trunks a breeze. You can view this wiki on how to use the SIPStation module.
Where can I get manual configuration instructions for other PBXs and Devices
What network ports do I need to forward to my PBX
in order to use my SIPStation service?
We recommend forwarding ports UDP/5060 and UDP/10000-20000 for standard FreePBX/Asterisk-based installs. If using newer versions of FreePBX, port 5160 is the default port for ChanSIP so that may be the port you need to forward. Check Asterisk SIP Settings for the bind port of ChanSIP. It may be possible to get your service working without port forwarding, but optimal service will be obtained with the above mentioned ports. You can lock down port UDP/5060 to or UDP/5160 depending on bind port of ChanSIP to the trunk1.freepbx.com and trunk2.freepbx.com FQDNs for additional security, but please note, we do from time to time change the IP addresses associated with these FQDNs. You can not Therefore it is best to use the FQDN and not an IP Address. You cannot lock down UDP/10000-20000 to any specific IP address as , since the media of a phone call can come from hundreds of different IP addresses.
If you are using SIPstation module in FreePBX/PBXact you will need to allow traffic from push2.schmoozecom.com for the module to work.
I would like to secure my system
. What IP addresses can I lock down open ports to?
You can lock down port 5060/UDP to trunk1.freepbx.com and trunk2.freepbx.com. You can not cannot lock down the media ports because the media servers vary and change. Most security issues that are reported are usually related to manufacture manufacturer vulnerabilities in their SIP stack, port 5060. By locking down this signalling signaling port, you should have be able to address almost all potential issues addressed.
What Codecs do you support?
We support g711 (ulaw) and g729.
Where can I get configuration instructions if I am not using FreePBX?
If you are using another Asterisk based PBX then you should be able to use the configuration instructions available atwww.freepbx.org/freepbx-trunks and adjust them for your specific Asterisk system. We do not currenlty have configuration instructions for other systems but there are plenty of users connected to our service with other systems so you should usually be able to get the service working. We require a SIP registration to receive inbound calls. We require a challenge response authentication for outbound calls. If your system is capable of this configuration (as most SIP capable systems are) then you should be able to configure our service.
Review our wiki on Standard versus Premium trunking here for Codec options. Difference Between Standard and Premium Trunking